Vodavi Starplus Triad-S, Manual

Page: 79 / 512

Centrex/PBX 2-53
Chapter 2 - Features and Operation
Operation
While connected to an outside line (PBX/Centrex):
1. Press the FLASH button. Receive transfer dial tone.
2. Dial a PBX/Centrex station number.
3. Hang up to complete the transfer.
PBX Dialing Codes
Description
Five 1- or 2-digit PBX access codes can be programmed into memory. When dialed, these
codes signal the system so toll restriction is applied at the next dialed digit. When a single
digit code [9] is entered, it must be followed by [#] as the second digit. Refer to
“911 Feature”
on page 2-4 .
Programming Steps
1. Press
FLASH
and dial
[12]
. The following message displays:
2. Enter valid numbers (one right after the other) on the dial pad, up to ten digits. If a single
digit code is required, enter the code followed by [#].
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
4. To delete a code, enter [#] [#] and press HOLD.
DEFAULT … No PBX dialing codes are assigned.
Conditions
»
Lines must be programmed as PBX lines before these codes apply.
If 911 is enabled for a PBX trunk using Centrex, entry one in Flash 12 (of [9] + [#]) will
insert the Centrex 9 (not LCR).
Quick Reference
➡
Flash 40 Page A Button #2 PBX/CO (Refer to
“CO / PBX Programming” on
page 2-50
.)
P B X DI A L CO DE S
# # , # # , # # , # # , # #