Vodavi Starplus Triad-S, Manual

Page: 107 / 512

CO Line - Ringing Options 2-81
Chapter 2 - Features and Operation
»
When in Flash 51 programming, if you press HOLD without specifying a flexible number
to be programmed, you will get the station that is in port/station 100.
CO Line Queue Button Flash Rate
Description
The Line Queue Button flash rate is the rate at which the Line Queue button flashes after
queueing onto a busy line. This button flashes when the busy line becomes available. This
flash rate can be programmed to 29 different options identified in the flash rate table which
enables the programmer to customize the key system configuration to desired flash rates.
Programming Steps
1. Press the LINE QUEUE BTN flexible button
(FLASH 07, Button #17)
.
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options. (Refer to Table 2-11 on page 2-130 .)
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … Line Queue Button flash rate is set for a Red 480 ipm Flutter (08).
CO Line - Ringing Options
Description
When a CO call rings at a busy station, the call rings at the station using a muted ring signal.
This option allows a user to receive a reminder ring at their busy station, instead of muted
ringing. A reminder ring timer is also available to provide the reminder ring every time the
timer expires, as long as the incoming CO line remains connected.
Use Flash 50 programming when you want to modify a range of stations’ attributes using
fixed station numbers.
Use Flash 51 programming to modify a single station’s attributes using a flexible station
number.
Programming Steps
1. Press FLASH and dial [50] or dial [51] . Flexible button #24 (New Range) is lit and one of
the following messages displays:
L IN E Q U E U E BT N 0 0-28
R E D 4 8 0 IP M F LU T T E R
Flash 50 - Fixed Numbers Flash 51 - Flexible Numbers
S TAT IO N AT T R IB UT E S
S E L E C T A S TAT I O N R A N G E E N T E R S TAT IO N N U M B E R