Vodavi Starplus Triad-S, Manual

Page: 151 / 512

Executive Override 2-125
Chapter 2 - Features and Operation
4. Press the EXECUTIVE OVERRIDE BLOCK flexible button
(Button #13)
. The following
message displays:
5. Enter a 0 or 1 on the dial pad to enable/disable this feature.
[0] = Disabled
[1] = Enabled
6. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … Executive Override Blocking is disabled at all stations.
Conditions
»
Only one station at a time can be programmed when using a flexible station number.
»
When in Flash 51 programming, if you press HOLD without specifying a flexible number
to be programmed, you will get the station that is in port/station 100.
Executive Override Warning Tone
Description
The Executive Override Warning enables Executive stations to override and barge-in on other
key sets engaged in conversation on a CO line. Prior to actual cut through of the third party, a
warning tone is presented to all parties notifying them of the barge-in. This warning tone,
however, is a programmable option on a system-wide basis, that either enables or disables
the tone. When tone is disabled, no audible signal is presented to parties to signal barge-in.
Programming Steps
1. Press the EXEC OVER WARN TONE flexible button (FLASH 05, Button #4) .
2. Enter a valid number (0 or 1) that corresponds with the following entries:
[0] = Disabled
[1] = Enabled
3. Press HOLD to save the entry. A confirmation tone sounds.
DEFAULT … Executive Override Warning Tone is enabled.
E X E C O VE R RI D E B LO C K 0-1
D IS AB L E D
Use of this feature when the Executive Override Warning Tone is disabled may be
interpreted as a violation of federal, state, or local laws, and an invasion of privacy.
Check applicable laws in your area before intruding on calls using this feature.
A change in volume may occur on the CO line or intercom call after the barge-in
occurs. This feature also affects ACD Supervisor Barge-in warning tone.
E X E C U T I VE WA R N I N G 0-1
E N A B LE D