Vodavi Starplus Triad-S, Manual

Page: 103 / 512

CO Line Loop and Pool Buttons 2-77
Chapter 2 - Features and Operation
Operation
To make a Loop button:
1. Press the SPEED button twice.
2. Press the desired flexible button.
3. Dial [89].
4. Press HOLD.
Conditions
»
Only one station at a time can be programmed when using a flexible station number.
»
When in Flash 51 programming, if you press HOLD without specifying a flexible number
to be programmed, you will get the station that is in port/station 100.
In-Use Hold (I-Hold) Flash Rate
Description
The In Use-Hold (I-Hold) flash rate is the rate at which a CO Line button or Loop button flashes
when a call is placed on In-Use Hold (I-Hold). This flash rate can be programmed to
29 different options identified in the flash rate table. This enables the programmer to
customize the key system configuration to desired flash rates.
Programming Steps
1. Press the IN-USE HOLD flexible button (FLASH 07, Button #14) . The following message
displays:
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options. (Refer to Table 2-11 on page 2-130 .)
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … In-Use Hold (I-Hold) flash rate is set for a Green 60 ipm Flash (17).
I N - U S E H OL D 0 0-28
G R E E N 6 0 IP M F L AS H