Vodavi Starplus Triad-S, Manual

Page: 179 / 512

Intercom 2-153
Chapter 2 - Features and Operation
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options. Refer to Table 2-11 on page 2-130 .
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … Incoming Intercom Ringing flash rate is set for Red 120 ipm Flutter (11).
Intercom Hold Button Flash Rate
Description
The Intercom Hold Button flash rate is the rate at which your Hold button flashes when you
receive an intercom call and your station’s intercom mode selector switch is in the
T position.
This flash rate can be programmed to 29 different options identified in the Flash Rate table.
This enables the programmer to customize the key system configuration to desired flash
rates.
Programming Steps
1. Press the ICM HOLD BTN flexible button (FLASH 07, Button #19) .
2. Enter a valid number (00-28) on the dial pad to correspond to one of the 29 available
options. (Refer to Table 2-11 on page 2-130 .)
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
DEFAULT … Intercom Hold Button flash rate is set for a Red 15 ipm Flash (09).
Intercom Signaling Select
Description
Users can control the method by which they receive intercom calls and signals. A convenient
intercom signal switch (electronic telephones) or HPT button (digital telephones) is located
on each telephone for easy selection. The choices are:
Handsfree (H) -- The station user, upon hearing a tone burst and voice announcement
over the speaker, can reply handsfree.
Privacy (P) -- The station user receives a burst of tone and a voice announcement over
their speaker. The microphone is deactivated for privacy. The called party must lift the
handset or press the MUTE button to answer the call.
Tone Ringing (T) -- A standard tone ring notifies the party of an incoming intercom call.
The called party answers by lifting the handset or moving the switch to the handsfree (H)
position or pressing the ON/OFF button.
Conditions
»
Use feature code 667 to select an H, P, or T mode for 8-button digital telephones. Each use of this
feature code acts as a rotary through the three options.
I C M H OL D B T N 0 0-28
R E D 1 5 IP M F L A S H