Sirona ORTHOPHOS XG 3 DS, Service Manual

Page: 97 / 578

båÖäáëÜ
59 38 399 D3352
D3352.076.01.13.02
07.2008
2 – 39
Tab 2 2.5 List of error messages
2.5
E6 42 20 Contact to DX11 interrupted during
operation
z
Check the signal path from board DX1 to board
DX42,
replace module, if necessary
z
Check connection of remote control,
see installation instructions
z
Checking the CAN bus
3-6
z
Check cable L17,
3-17
replace if necessary
6-91
z
Check board DX42,
3-12
replace if necessary
6-59
z
Check board DX41,
3-12
replace if necessary
6-59
HINWEIS
i
If the error cannot be eliminated immediately, the
unit can be temporarily reconfigured and operated
with a release button located directly on the unit (see
installation instructions)
E7 42 21 No CAN bus connection.
DX11 does not start.
Note:
Occurs after power-on in the start
screen.
z
Check configuration (with or without DX41) via
service routine S017.9,
5-91
configure correctly if necessary
5-91
z
Check the signal path from board DX1 to board
DX42,
replace module if necessary
z
Checking the CAN bus
3-6
z
Check remote control via service routine 17.6,
configure if necessary
5-87
z
Start the detail query via Sixabcon
z
If DX11 responds...
z
Check the signal path to DX42,
repair or replace cable/connector if necessary
6-91
z
Replace DX1
6-59
If DX11 does not respond...
z
Replace DX11 if this error persists
6-59
E3 42 30 R key actuated during power-on
z
Unit restart:
Switch the unit OFF. Wait for 30 sec.
Switch unit ON, making sure that the remote
control is not actuated during boot-up.
If the error occurs again...
z
Replace remote control,
see installation instructions
Error code Description Actions required see page