Sirona ORTHOPHOS XG 3 DS, Service Manual, Page: 527 / 578

båÖäáëÜ
59 38 399 D3352
D3352.076.01.13.02
07.2008
6 – 95
Tab 6 6.21 Replacing cables
6.21
Removing the cable track 1. Detach fiber optic cable L7 and cable L8/L108* from the cable clamps at
the rear of the unit and pull the cables through the slit in the slide toward
the front into the stand.
2. Unscrew the angle brackets on both sides of the cable track.
3. Remove the motor-side end piece from the cable track.
z
Remove both cable covers (on the right and on the left in the stand) and
pull the cable track (behind the motor) down and out of the stand.
Detaching old cables from the cable
track 4. If cable L7 is defective:
Unscrew cable L7 from the interface board and remove the shielding.
NOTE
i
This step is not required if cable L7 is intact and therefore will be reused. Un-
less it is not possible to lay down the cable track flat near the stand (see next
step)
z
Remove the cable ties from the cable track and lay the cable track down
on a flat surface stretched out.
5. Carefully pull both cables (together) out of the cable track and out of the
fabric tube.
CAUTION
At the same time, be sure to check the position of connector X303 on cable
L8/L108* (see photo above).
*) unit HW version
≥
AG
1. 2.
3.
5.
X303
4.