Sirona ORTHOPHOS XG 3 DS, Service Manual, Page: 95 / 578

båÖäáëÜ
59 38 399 D3352
D3352.076.01.13.02
07.2008
2 – 37
Tab 2 2.5 List of error messages
2.5
Location 42: Remote control, board DX42
Error code Description Actions required see page
E6 42 01 General module initialization error
Note:
Error generated during module self-
test
z
Check unit configuration (with or without DX41)
via service routine S017.9,
5-91
configure correctly if necessary
5-91
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
z
Replace board DX42
6-59
E6 42 02 Invalid system data or uninitialized
module storage data
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
z
Acknowledge error and repeat procedure
If the error occurs again...
z
Replace board DX42
6-59
E6 42 03 Invalid commanding or control data
Note:
This error may also occur in connec-
tion with other causal error messages.
Please also observe the causal error
message! It appears only after you
acknowledge the first error message.
z
Check software version of DX42 (in comparison
to overall software version) via service routine
S008.2,
5-48
perform a software update if necessary
1-22
z
Checking the CAN bus
3-6
z
Check the signal path from board DX1 to board
DX42,
replace module DX42 if necessary
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
E6 42 04 Data transfer error or dialog error to
module (master side)
z
Checking the CAN bus
3-6
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
E6 42 05 Data transfer error or dialog error to
bootloader of module
Note:
Occurs only in connection with
software update
z
Repeat software update
1-22
z
Checking the CAN bus
3-6
z
Replace board DX42
6-59
E6 42 06
Module failed in TTP*
(detected on master side)
z
Checking the CAN bus
3-6
z
Check the signal path from board DX1 to board
DX42,
replace module, if necessary
z
Replace board DX42
6-59
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22