Sirona ORTHOPHOS XG 3 DS, Service Manual

Page: 106 / 578

59 38 399 D3352
2 – 48
D3352.076.01.13.02 07.2008
2.5 List of error messages Tab 2
E6 71 07 TTP* timeout error
(detected on slave side)
Note:
The module was temporarily not
addressed by the master:
- Undervoltage on the master side
- Procedure error in the software
- Master (DX11) receives no
return commanding from the module
Note:
This error may also occur in connec-
tion with other causal error messages.
Please also observe the causal error
message! It appears only after you
acknowledge the first error message.
z
Checking the CAN bus
3-6
z
Check power supply of board DX11; measuring
point 3.3 V on board DX1 (see wiring diagrams).
– If 3.3 V are present, replace board DX11
6-59
– If 3.3 V are not present, replace board DX1
6-59
E6 71 08 General fault detected locally on mod-
ule (slave side). CAN controller being
reinitialized.
z
Checking the CAN bus
3-6
z
Check software versions via info screen or ser-
vice routine S008.2,
5-48
perform a software update if necessary
1-22
z
Check board DX71 or
3-59
z
replace Multipad
6-21
z
Please contact the Sirona Customer Service
Center (CSC) to find out whether a bugfix by
means of a software update is possible and per-
form such an update if necessary.
1-22
E7 71 10 Module is stuck in bootloader stage
z
Check board DX71
3-12
If the board remains in the bootloader stage...
z
Repeat software update
1-22
z
Check board DX71 or
6-59
replace Multipad
6-21
E7 71 12 Unit is not ready for operation
z
Checking the CAN bus
3-6
This error is a sequential fault.
z
Unit restart:
Switch the unit OFF. Wait 30 sec.
Switch unit ON.
z
Repeat procedure and observe causal error
messages.
E6 71 20 Contact to DX11 interrupted during
operation.
z
Note error message on remote control (DX42)
and check log memory (via extended details)
z
Checking the CAN bus
3-6
z
Check cable L9,
3-17
replace if necessary
6-91
Error code Description Actions required see page