Sirona ORTHOPHOS XG 3 DS, Service Manual

Page: 508 / 578

59 38 399 D3352
6 – 76
D3352.076.01.13.02 07.2008
6.20 Replacing circuit boards Tabs 6
NOTE
i
In systems that already run with a system software version V02.27 or higher,
please check that there is a XML file in the PDATA/P2K_Config with the net-
work name of the system (Extended details). This file contains up-to-date in-
formation about the previous system configuration! See also section 1.10, on
page 1-32).
9. Start service routine S034.7 and select ring type 02 (see page 5-145).
10. Start service routine S017 and check the system configuration or perform
the system configuration (test step 2-23) (see page 5-78).
NOTE
i
For the XG 3: Service routine S017.17 must be set according to the serial
number of the unit (see page 5-103).
11. If the minimum travel height of the system must be limited:
Set the travel height with service routine
S018.2 . (see page 5-110).
12. Perform the complete system adjustment (see chapter 4):
– PAN adjustment
– CEPH adjustment, if installed
13. Perform another software update to the current system software version
as described in section 1.9.3. This updates all modules in accordance
with the configuration.
14. Open the "Extended Details“ via SIXABCON.
This generates an XML file (with the system parameters) which is saved
under the network name of the system in the PDATA/P2K_Config folder
(see also section 1.10 on page 1-32).
z
The process is completed.