Rohde & Schwarz R&S UPP, User Manual

Page: 829 / 938

Remote Control - Command Description
R&S
®
UPP
813 User Manual 1411.1055.32 ─ 10
SENSe<1|2|6>:UNIT <unit>
Suffix:
<1|2|6>
.
specifies the type of measurement.
1 = function measurement (level / signal to noise / distortion, ...)
2 = input or second monitor measurement
6 = level monitor measurement
Parameters:
<unit> selection
Manual operation: See "Unit" on page 585
SENSe<1|2|6>:USERunit <userunit>
Suffix:
<1|2|6>
.
specifies the type of measurement.
1 = function measurement (level / signal to noise / distortion, ...)
2 = input or second monitor measurement
6 = level monitor measurement
Parameters:
<userunit> string
Manual operation: See "Unit Auto" on page 585
7.26 Softkey Commands of the Graphical Display
This section includes all commands of the softkey menu of the graphical and list dis-
plays. These commands cannot be recorded.
Only a few commands are allowed in all subsystems. Commands that are not allowed
in a subsystem are not listed here.
In the
BARGraph
subsystem, for example, there are no markers.
The
DISPlay:BARGraph<n2>:A|B:MARKer:HARMonics ON | OFF
command is
thus not allowed, and is not listed in the following command description.
The value range for suffix <n2> depends on the subsystem:
For the Subsystem SWEep: <n2> = 1 … 4
For the Subsystem FFT: <n2> = 1 | 2
For the Subsystem BARGraph: <n2> = 1 | 2
For the Subsystems WAVeform: <n2> = 1
●
DISPlay:BARGraph<n2>:DLISt:FILTer
on page 799
●
DISPlay:BARGraph<n2>:OCURsor:MODE
on page 818
●
DISPlay:BARGraph<n2>:OCURsor:POSMode
on page 819
Softkey Commands of the Graphical Display