Rohde & Schwarz R&S UPP, User Manual

Page: 262 / 938

Instrument Functions
R&S
®
UPP
246 User Manual 1411.1055.32 ─ 10
Sweep points: Linear or logarithmic between Start and Stop or read out of the file.
Forwarding: Automatic in a defined timeframe or synchronized to the measurement
time of the analyzer. All setting parameters of the sweep system are described in detail
in
Chapter 5.9, "Sweeps" , on page 285.
Remote command:
SOURce:SWEep:CONTrol
on page 718
Upper Freq
Used to set the frequency of the high-frequency wanted signal.
Remote command:
SOURce:FREQuency<n2>
on page 697
Lower Freq
Used to set the frequency of the low-frequency unwanted signal.
Remote command:
SOURce:FREQuency<n2>
on page 697
Volt LF:UF
Used to set the level ratio of unwanted signal to wanted signal as a dimension-less
number.
Remote command:
SOURce:VOLTage:RATio
on page 702
Total Voltage
Used to set the level of the overall signal. The maximum RMS value depends on the
level ratio. The maximum value depends on the configured DC offset. In the analog
generator, the maximum total voltage also depends on the settings for Output Type
and Max Voltage in the Generator Config panel.
Remote command:
SOURce:VOLTage:TOTal
on page 704
Filter
The generator signal is filtered in the time domain. One of the user
‑
definable filters in
the Filter panel or a weighting filter can be selected. All level settings apply to the unfil-
tered signal.
Remote command:
SOURce:FILTer
on page 776
For a description of the filters and their setting parameters, see Chapter 5.39.4, "Filter
Table" , on page 468.
DC Offset
Generator Signals