Rohde & Schwarz R&S UPP, User Manual

Page: 389 / 938

Instrument Functions
R&S
®
UPP
373 User Manual 1411.1055.32 ─ 10
Remote command:
SENSe[1]:FREQuency:SELect
on page 755
SENSe[1]:FREQuency
on page 755
Factor
Used to enter the factor by which the center frequency of the bandpass filter or band-
stop filter is to be higher than the generator frequency. Only visible in "Freq Mode Gen
Track".
Setting an integer factor greater than 1 will therefore allow an individual harmonic to be
measured. If the fundamental is to be selected, the factor must be set to 1.
Remote command:
SENSe[1]:FREQuency:FACTor
on page 755
5.21.4 Peak Measurement
Measurement of the peak value of any given signal, and the rise and fall of the mea-
sured value all occur without a delay. The measured value contains both AC and DC
components.
If a square wave is applied, it is limited with respect to bandwidth by the upper mea-
surement limit of the selected analyzer, and overshoots occur at the edges (Gibbs phe-
nomenon). The overshoots are also measured during the peak analysis, which means
that the returned measured value may be greater than the input peak. FS values
greater than 1 may be measured, especially in the digital range.
For more settings, see Chapter 5.21, "Level Measurements" , on page 359.
Function (Peak)
Selection of peak measurement.
Remote command:
SENSe[1]:FUNCtion PEAK
Level Measurements