Rohde & Schwarz R&S UPP, User Manual

Page: 752 / 938

Remote Control - Command Description
R&S
®
UPP
736 User Manual 1411.1055.32 ─ 10
ARM:VOLTage:STARt <start>
Parameters:
<start> float
Manual operation: See "Start" on page 351
ARM:VOLTage:STOP <stop>
Parameters:
<stop> float
Manual operation: See "Stop" on page 352
7.5.4 Reading Measurement Results
Depending on the measurements activated in the Analyzer panel, the Audio Analyzer
indicates up to eight results in the numeric display in the case of a two-channel instru-
ment and up to 64 results in the case of a multichannel instrument. The results are also
available in buffers from where they can be read by remote control.
●
SENSe<1|2|3|6>:DATA<n2>?
on page 736
●
SENSe<1|2|3|6>:DATA:ALL?
on page 738
SENSe<1|2|3|6>:DATA<n2>? <data>
The command retrieves the selected measurement result of the selected channel. The
type of measurement is defined by suffix <1|2|3|6>, the channel by suffix <n2> (for suf-
fix range see below).
The figure below shows the assignment of remote control commands to the results
indicated in the numeric display for an 8-channel analyzer.
For reasons of compatibility with the R&S UPL, in dual-measurement mode, a phase-
or group-delay measurement result can be retrieved with
SENS4:DATA?
in addition to
command
SENS3:DATA2?
.
Figure 7-1: Numeric Display and associated remote control commands
The query with
MIN
and
MAX
indicates the minimum and maximum measured value
shown in the combi display above the measured value.
Triggering Measurements and Reading Results