Rohde & Schwarz R&S UPP, User Manual

Page: 749 / 938

Remote Control - Command Description
R&S
®
UPP
733 User Manual 1411.1055.32 ─ 10
SINGle
Start of a single measurement.
In the case of a stopped measurement or an in-progress single
measurement identical to the [SINGLE] stroke.
Identical to
INITiate:CONTinuous OFF
; however, without
changing the
INITiate
presetting.
CONTinuous
Start of a continuous measurement; however, without reset func-
tion.
This retains the MIN/MAX values and limit violations, and mea-
surement is started several milliseconds faster.
Manual operation: See "STOP/CONT" on page 340
See "STOP/CONT" on page 341
See "STOP/CONT" on page 341
See "START" on page 355
See "SINGLE" on page 355
See "STOP/CONT" on page 355
See "START" on page 356
See "SINGLE" on page 356
See "STOP/CONT" on page 356
See "START" on page 357
See "SINGLE" on page 357
See "START" on page 358
See "SINGLE" on page 358
INITiate
Starts a measurement according to the mode preset by
INITiate:CONTinuous
(continuous or single measurement).
ABORt
Identical to
INITiate:FORCe STOP
.
Stops a measurement as if [STOP/CONT] was pressed while a measurement was in
progress.
7.5.2 Start Conditions
The following commands define the start conditions for the measurement.
●
TRIGger:CHANnel
on page 734
●
TRIGger:COUNt
on page 734
●
TRIGger:DELay
on page 734
●
TRIGger:FREQuency:VARiation
on page 734
●
TRIGger:SOURce
on page 734
Triggering Measurements and Reading Results