Rohde & Schwarz R&S UPP, User Manual

Page: 374 / 938

Instrument Functions
R&S
®
UPP
358 User Manual 1411.1055.32 ─ 10
5.20.3.4 Stopped sweep
The measurement system only assumes this state when the [STOP/CONT] key is
pressed while a measurement is being performed. Valid measured values and data
sets from the sweep point last set are available. However, only some of the measured
values of the sweep trace are available. Sweep traces should not be read out via the
remote-control station when the system is in this state.
The sweep state is indicated by "Sweep Stopped"; none of the LEDs light up.
A stopped sweep is affected by the following events:
START
Pressing [START ]
●
deletes the sweep curves (in multiscan mode all scans are deleted) including the
min/max curves
●
resets the Min/Max. data and the limit violations of the sweep curves
●
starts a continuous sweep
Remote command:
INITiate:CONTinuous
on page 731
ON
INITiate:FORCe
on page 732
STARt
SINGLE
Pressing [SINGLE ] causes the single sweep to be restarted.
Remote command:
INITiate:CONTinuous
on page 731
OFF
INITiate:FORCe
on page 732
SINGle
STOP/CONT
Pressing [STOP/CONT] continues the sweep.
Remote command:
-
Termination event
… starts the continuous measurement (see Chapter 5.20.1, "Overview of Sweep
Options" , on page 353).
5.20.4 Several Sweep Traces in One Diagram
Up to 2 traces can be displayed in every sweep window. There are two options for dis-
playing the sweep traces. These options can be selected in the individual sweep win-
dows:
●
Each new sweep cycle deletes the old trace; only one trace (or trace pair) is visible
at any one time (single-scan mode).
●
Each new sweep cycle plots a new trace without deleting the old trace; all recorded
traces are visible (multi-scan mode).
Sweep Options