Rohde & Schwarz R&S UPP, User Manual

Page: 290 / 938

Instrument Functions
R&S
®
UPP
274 User Manual 1411.1055.32 ─ 10
Remote command:
SOURce:MCHannel<n2>:SINE:STATe
on page 714
Frequency
Frequency of the channel-based sine-wave signal
Remote command:
SOURce:MCHannel<n2>:SINE:FREQuency
on page 714
Phase
For signals with the exact same frequency and activated higher-level sine-wave sig-
nal , a two
‑
tone signal is generated in every channel at which the channel
‑
based sine
wave has the specified phase regarding the higher
‑
level sine
‑
wave signal.
With deactivated higher
‑
level sine
‑
wave signal , the channels have the difference of
their phase entries as phase relationship among each other.
Remote command:
SOURce:MCHannel<n2>:SINE:PHASe
on page 714
Voltage
Level of the channel-based sine-wave signal
Remote command:
SOURce:MCHannel<n2>:SINE:VOLTage
on page 714
Equalizer
The content of the equalization file affects the adjustable level range of the channel-
based sine wave. If the selection of "Equalization" results in a level increase, it leads to
the cutoff of level values if the overall signal of 1 FS is exceeded.
The channel
‑
based sine
‑
wave signal is equalized in the frequency domain based on
the entries in the "Equal File".
The checkbox enables or disables this function.
The button opens a browser in which you can select the equalizer file, refer also to
Chapter 5.7, "Equalization" , on page 279.
Remote command:
MMEMory:LOAD:MCHannel<n3>:SINE:EQUalize
on page 711
SOURce:MCHannel<n2>:SINE:EQUalize:STATe
on page 713
DC Offset
A DC voltage is added to the overall signal.
The checkbox enables or disables this function.
Generator Signals