Rohde & Schwarz R&S UPP, User Manual

Page: 553 / 938

Instrument Functions
R&S
®
UPP
537 User Manual 1411.1055.32 ─ 10
Limit violations are marked by red dots on a curve or by red bars on a bar graph.
An additional display in the bottom right corner of the graphical display with an arrow
pointing
upward marks the over ranging of the upper limit or limit line.
See Chapter 5.47.1, "Graphical Display, Explanation of the Elements" , on page 569
for the meaning of the limit violation symbols.
Pressing the [START ] key causes the existing limit overranging to be reset and new
violations to be recorded.
Available in the graphics subsystems
Sweep, FFT, Waveform, Bar Graph
Remote command:
DISPlay:SWEep<n2>:A:LIMUpper
on page 793
DISPlay:SWEep<n2>:B:LIMUpper
on page 793
Source
Used to determine how the upper limit is set.
"Value "
Available in the graphics subsystems
Sweep, FFT, Waveform, Bar Graph
Input of a fixed limit value for the Source
= Value setting.
In the parameter field below, an upper limit constant for all X values is
entered in the unit which has been selected in the Unit
Funct Track
parameter field. If a relative unit is selected, the associated reference
value (a few parameter fields higher up) is used.
All scans of a trace (except the Min/Max scans) are compared to this
common limit and the limit violations are marked.
Curve, Spectrum and Bar Graph Display