Rohde & Schwarz R&S UPP, User Manual

Page: 371 / 938

Instrument Functions
R&S
®
UPP
355 User Manual 1411.1055.32 ─ 10
Table 5-3: The following states are possible:
Off Sweep is deactivated; the measurement system is controlled directly by the user.
Single Single sweep is being performed
Cont Continuous sweep is being performed
Waiting Sweep is waiting for a (re)start; has been reactivated or has been run at least once as
a single sweep.
Stopped Sweep has been stopped; can be continued or restarted.
5.20.3.1 Continuous sweep
Continuous sweeps are started with [START ]. The sweep state is indicated by "Sweep
Cont ". When the sweep reaches the stop value of the x-axis or the end of the X sweep
list, it starts again at the start value. This is repeated until one of the following events
occurs:
START
Pressing [START ]
●
interrupts the currently running sweep at once
●
deletes the sweep curves (in multiscan mode all scans are deleted) including the
min/max curves
●
resets the Min/Max. data and the limit violations of the sweep curves
●
causes the continuous sweep to restart
Remote command:
INITiate:CONTinuous
on page 731
ON
INITiate:FORCe
on page 732
STARt
SINGLE
Pressing [SINGLE ] switches to single sweep. The remaining points are plotted on the
trace and the sweep system then enters the "Sweep Waiting" state.
Reactivation of continuous sweep with [START ];
Remote command:
INITiate:CONTinuous
on page 731
OFF
INITiate:FORCe
on page 732
SINGle
STOP/CONT
Pressing [STOP/CONT ] terminates the current measurement and pauses the sweep
system (Sweep Stopped state).
Reactivation of continuous sweep either with [START ] (starts from the beginning) or by
pressing [STOP/CONT ] again (resumes the sweep from the point where it was stop-
ped).
Remote command:
INITiate:FORCe
on page 732
STOP
Sweep Options