Rohde & Schwarz R&S UPP, User Manual

Page: 558 / 938

Instrument Functions
R&S
®
UPP
542 User Manual 1411.1055.32 ─ 10
This enables limit lines or limit curves to be shifted according to the parameters in the
subsequent parameter fields "Parallel" and "Symmetrical".
If the Limit Shift function is enabled without activating limit monitoring, the subsequent
parameter fields should be regarded as default settings.
Available in the graphics subsystems
Sweep, FFT, Waveform, Bar Graph
Remote command:
DISPlay:SWEep<n2>:A:LIMShift
on page 793
DISPlay:SWEep<n2>:B:LIMShift
on page 793
Parallel
This enables limit lines or limit curves to be parallel shifted.
In this way limit curves derived from a "golden unit", for example, can be adapted very
easily to new circumstances
The limit lines, which were determined using -100 dBV and -150 dBV, are to be paral-
lel shifted by a value of 25 dBV to -75 dBV and -125 dBV.
Available in the graphics subsystems
Sweep, FFT, Waveform, Bar Graph
Remote command:
DISPlay:SWEep<n2>:A:LIMShift:PARallel
on page 793
DISPlay:SWEep<n2>:B:LIMShift:PARallel
on page 793
Symmetrical
This enables a tolerance band formed from two limit lines or limit curves to be made
broader or narrower
In this way a tolerance band derived from a "golden unit", for example, can be very
easily narrowed or broadened.
Curve, Spectrum and Bar Graph Display