Rohde & Schwarz R&S UPP, User Manual

Page: 357 / 938

Instrument Functions
R&S
®
UPP
341 User Manual 1411.1055.32 ─ 10
STOP/CONT
[STOP/CONT] stops the current measurement immediately and causes the measure-
ment system to enter the "Stop" state. Reactivating the single measurement with
[SINGLE ].
Remote command:
INITiate:FORCe
on page 732
Break event
.. stops the current measurement immediately and starts a new single measurement
(see
Chapter 5.15.1, "Overview of the Measurement System" , on page 337).
5.15.3.3 Terminated measurement
The measurement system only assumes this state when a single measurement is fin-
ished. No further measurements are performed; the measured values and data sets
are frozen until the next measurement is started. Measured values should be read out
via remote-control only in this state. The control keys have the following function:
START
[START ] resets the MIN/MAX indicator, the Min/Max values and the limit violations of
the measurement displays, and causes continuous measurement to be started.
Furthermore, starting or restarting a measurement also causes certain generator func-
tions to restart:
●
The sine-burst burst signal is reset, that is, it starts with the burst phase or burst on
delay.
●
The Play function starts again at the first sample in the WAV file.
●
The Arbitrary function also starts again at the beginning.
Remote command:
INITiate:CONTinuous
on page 731
SINGLE
[SINGLE ] causes the start of a single measurement.
Restarting the single measurement also causes a restart of the "sine burst" burst sig-
nal, that is, it starts at the burst phase or "Burst on Delay".
Remote command:
INITiate:CONTinuous
on page 731
STOP/CONT
[STOP/CONT ] causes the start of continuous measurement.
Remote command:
INITiate:FORCe
on page 732
Break event
... stops the current measurement immediately and starts a new single measurement
(see
Chapter 5.15.1, "Overview of the Measurement System" , on page 337). In
remote-control mode, the automatic measurement start is disabled so that setting com-
mands can be dealt with at maximum speed.
Starting Measurements