Rohde & Schwarz R&S UPP, User Manual

Page: 373 / 938

Instrument Functions
R&S
®
UPP
357 User Manual 1411.1055.32 ─ 10
Termination event
… stops the current sweep immediately and causes the single sweep to be restarted
(see
Chapter 5.20.1, "Overview of Sweep Options" , on page 353).
X stop value reached
The single sweep is stopped; the sweep system changes to the "Sweep Waiting" state.
Remote command:
-
5.20.3.3 Terminated sweep
The sweep system only enters this state if a single sweep or a 2-dimensional continu-
ous sweep is terminated. No further measurements are performed; the measured val-
ues, data sets and sweep traces are frozen. Sweep traces should only be read out via
the remote-control station when the system is in this state.
The sweep state is indicated by "Sweep Waiting ".
A terminated single sweep is affected by the following events:
START
Pressing [START ]
●
deletes the sweep curves (in multiscan mode all scans are deleted) including the
min/max curves
●
resets the Min/Max. data and the limit violations of the sweep curves
●
starts a continuous sweep
Remote command:
INITiate:CONTinuous
on page 731
ON
INITiate:FORCe
on page 732
STARt
SINGLE
Pressing [SINGLE ] causes the single sweep to be restarted.
Remote command:
INITiate:CONTinuous
on page 731
ON
INITiate:FORCe
on page 732
SINGle
STOP/CONT
Pressing [STOP/CONT ] starts continuous measurement. Reactivating the single
sweep with [SINGLE ].
Remote command:
-
Termination event
… starts the continuous measurement (see Chapter 5.20.1, "Overview of Sweep
Options" , on page 353).
Sweep Options