Rohde & Schwarz R&S UPP, User Manual

Page: 108 / 938

Getting Started
R&S
®
UPP
92 User Manual 1411.1055.32 ─ 10
a) The basic settings for configuring the generator are made in the "Generator
Config" panel.
The frequency response is usually measured on both channels; this is already
configured in the "Channel" field.
From serial numbers 120100, 140100, 180100 and depending on the DUT, the
"Output Type" field allows switching over to balanced circuitry with the optional
output impedance of 25
Ω
or 600
Ω
.
If needed, click on the corresponding parameter field and perform the desired
selection.
b) A maximum signal frequency of 22 kHz is generally the correct setting here.
The following settings are also suitable for the majority of applications and do
not have to be adjusted unless necessary.
This completes the settings in the "Generator Config" panel.
c) Next, the "Generator Function" panel is activated using the mouse.
Sine-wave signals are required; this setting is already selected.
To be able to measure the frequency response, the sine-wave signal must be
swept in the frequency. A fixed frequency of "1
kHz" is preset in the default
instrument setup.
To activate the sweep, select the "Sweep
Ctrl" field, open the parameter list
and select the desired setting.
Introduction to Instrument Operation Using Examples