Rohde & Schwarz R&S UPP, User Manual

Page: 141 / 938

Manual Operation
R&S
®
UPP
125 User Manual 1411.1055.32 ─ 10
4.4.4.1 Status Displays
The status of the R&S UPP is continuously displayed for the generator, analyzer,
sweep system and other instrument states at the bottom of the screen above the four
right-hand softkeys. Status displays always appear at the same position; they are
assigned to the fields above the softkeys as shown below.
A list of all possible status messages is available, see Chapter 4.20, "Overview of Sta-
tus Messages" , on page 193.
4.4.4.2 Valid Value Range
Information on the possible entries is given at the bottom of the screen above the soft-
key bar. The ranges for value entries specified here always take the current status of
the instrument into consideration and therefore depend on the presets already config-
ured. Below is an example for entry of the generator output voltage:
4.4.4.3 Notes
Information concerning the panel settings and so on is also given at the bottom of the
screen above the softkey bar (only the space above the four left-hand softkeys is
used).
4.4.4.4 Warnings
If the user attempts to make measurement settings which conflict with the usual test
specifications, warnings appear on the screen; these remain there until they are
acknowledged with ENTER or a mouse click on OK.
Warnings are issued if no measurement results are produced during measuring mode.
This is normally the result of unsuitable input signals or settings. For example, input
signals may be too low to produce a stable measurement result. In this case, a warning
is displayed in the middle of the screen instead of the measurement result. The warn-
ing indicates why no measurement result can be displayed and may also list several
reasons for this.
The Display