Rohde & Schwarz R&S UPP, User Manual

Page: 48 / 938

Startup
R&S
®
UPP
32 User Manual 1411.1055.32 ─ 10
[TRIGGER OUT]
●
Required for cascading and must be connected with TRIGGER IN of the next
instrument
●
The trigger output level is 3.3 V
●
Can be used for connecting to a device under test.
2.2.4 BNC monitor outputs
The instrument settings determine which signal is present at these BNC sockets:
●
The input signal (maximum
±
5 V peak)
●
The filtered signal from the analyzer (maximum
±
5 V peak)
●
Starting with serial numbers 120100, 140100, 180100, a DC level (maximum
±
5 V)
The maximum output level is limited to
±
5 V peak
2.2.5 AC Supply Voltage Connector
AC supply voltage connector with integrated power switch
Shutting down the operating system
It is urgently recommended to shut down the operating system first before switching off
the instrument via the power switch by switching off the instrument with the standby
mode pushbutton (POWER LED should be orange before the shutdown).
[AC Supply Voltage Connector]
If the instrument is connected to the AC supply voltage, it automatically adjusts to the
AC supply voltage (see the labeling for the voltage range). It is not necessary to man-
ually adjust the instrument for a specific voltage or to change the fuse!
[Fuse carrier]
The fuse holder contains two fuses and is located between the AC supply voltage con-
nector and the power switch. Both fuses protect the circuit.
[Power switch]
The power switch has two positions:
Description of the Rear Panel