Rohde & Schwarz R&S UPP, User Manual

Page: 768 / 938

Remote Control - Command Description
R&S
®
UPP
752 User Manual 1411.1055.32 ─ 10
7.7 Selecting Measurement and Mode
The measurement type and measurement mode is selected with the two SENSe-com-
mands
SENSe:FUNCtion
and
SENSe:FUNCtion:MMode
.
In addition the more specific measurement mode commands
SENSe:FUNCtion:APERture:MODE
and
SENSe:VOLTage:APERture
are descri-
bed.
●
SENSe<1|2|3|6|7|8>:FUNCtion
on page 752
●
SENSe[1]:FUNCtion:APERture:MODE
on page 753
●
SENSe[1]:FUNCtion:MMODe
on page 753
●
SENSe[1]:VOLTage:APERture
on page 754
SENSe<1|2|3|6|7|8>:FUNCtion <state>
specifies the measurement.
Important:
This command selects all function measurements and several other types of measure-
ment, see below. The following description is valid for all types of measurements. See
also
Chapter 5.15, "Starting Measurements" , on page 337.
Suffix:
<1|2|3|6|7|8>
.
specifies the type of measurement.
1 = function measurement (level / signal to noise / distortion, ...)
2 = input monitor measurement
3 = frequency, phase, or group delay measurement
6 = level or function monitor measurement
7 = waveform monitor
8 = protocol analysis
Parameters:
<state> string
SENSe[1]:
RMS, RMSSelect, PEAK, SN, FFT, THD, THDNsndr, MDISt,
DFD, POLarity, NOCTave, DELay, LIPSync, BERT, CHIRpbased
SENSe2:
OFF, IRMS, DC, IPEak, RMSFft. DCFft
SENSe3:
OFF, FREQuency, FQPHase, FQGRoupdelay, FQSamplefre-
quency, SFRequency
SENSe6:
OFF, PEAK, DC, LRMS
SENSe7:
ON, OFF
SENSe8:
ON, OFF
Selecting Measurement and Mode