Rohde & Schwarz R&S UPP, User Manual

Page: 601 / 938

Instrument Functions
R&S
®
UPP
585 User Manual 1411.1055.32 ─ 10
Unit
This parameter field is used to determine the unit in which the measurement results
are to be displayed.
The parameter list available in this parameter field depends on whether the analog or
digital analyzer instrument has been selected and under which of the 4 analyzer mea-
surement functions the panel was opened.
●
Function
●
Level Monitor
●
Input measurement
●
Frequency/phase measurement
Approx. 30 different units are available to allow all measurement functions of the ana-
lyzer to be displayed.
If a logarithmic unit (dBu, dBV, dBr, dBm, dBFS, dBUI) or a linear unit in which negative
numbers can occur (e.g. ∆V, ∆W) is selected, the following parameter field "Spacing" is
displayed as not user-accessible and its parameter is set to "Lin", since it makes no
sense to display measurement values with a logarithmic unit or negative values on a
logarithmically scaled axis.
Remote command:
SENSe<1|2|6>:UNIT
on page 813
SENSe3:FREQuency:UNIT
on page 807
SENSe3:PHASe:UNIT
on page 811
Unit Auto
Used to determine whether the unit label displayed in the numeric display and in the
combo display is the same as that set in the Unit parameter field above or whether it
can be user-selected.
"activated"
The unit label displayed in the numeric display and in the combo dis-
play is the same as the unit set in the Unit parameter field and is
therefore generated automatically by the R&S
UPP.
Combi Display