Rohde & Schwarz R&S UPP, User Manual

Page: 746 / 938

Remote Control - Command Description
R&S
®
UPP
730 User Manual 1411.1055.32 ─ 10
SENSe[1]:HDMI:VIDeo:COLor:DEPTh? <depth>
Return values:
<depth> D08 | D10 | D12
Usage: Query only
Manual operation: See "Color Depth" on page 326
SENSe[1]:HDMI:VIDeo:FORMat?
Usage: Query only
Manual operation: See "Format No" on page 326
SENSe[1]:HDMI:VIDeo:TIMing <timing>
Parameters:
<timing> ON | OFF
Manual operation: See "Timings" on page 326
7.5 Triggering Measurements and Reading Results
This chapter describes how to start single measurements or continuous measurements
and how to read results from the instrument by means of remote control commands.
These commands cannot be logged by means of the SCPI recording function.
7.5.1 Starting Measurements
See also Chapter 5.15, "Starting Measurements" , on page 337
Continuous measurement
This is the standard operating mode of the measurement system to which the Audio
Analyzer is set on switch-on. All types of measurements that are activated are per-
formed continuously. Command
INIT:CONT ON
starts a continuous measurement.
The START LED is on to indicate that the continuous measurement mode is active.
In this operation mode, every change in the generator, analyzer or filter bank triggers a
restart of the continuous measurement in progress. This also applies to the
*RST
com-
mand and the loading of setups.
This ensures that the displayed measurement data is not corrupted by internal switch-
ing operations of the analyzer or by a change of the generator signal. The execution
time of the setting commands in question takes a bit longer in comparison to a stopped
measurement. To keep setting times as short as possible, you should execute longer
command sequences in the "term"inated or "stop" state, i.e. during stopped measure-
ments.
Triggering Measurements and Reading Results