Rohde & Schwarz R&S UPP, User Manual

Page: 834 / 938

Remote Control - Command Description
R&S
®
UPP
818 User Manual 1411.1055.32 ─ 10
O Cursor | X Cursor
Parameters:
<state> ONCE | EXEC
ONCE or EXEC can also be omitted.
ONCE
Set marker to position of O cursor | X cursor
EXEC
Alias to ONCE.
Example: DISPlay:SWEep:A:MARKer:SETTo:XCURsor
DISPlay:SWEep:A:MARKer:SETTo:XCURsor ONCE
DISPlay:SWEep:A:MARKer:SETTo:XCURsor EXEC
the three commands are equivalent.
DISPlay:FFT<n2>:A:MARKer:SETTo:XPOS <xpos>
DISPlay:FFT<n2>:B:MARKer:SETTo:XPOS <xpos>
DISPlay:WAVeform<n2>:A:MARKer:SETTo:XPOS <xpos>
DISPlay:WAVeform<n2>:B:MARKer:SETTo:XPOS <xpos>
DISPlay:SWEep<n2>:A:MARKer:SETTo:XPOS <xpos>
DISPlay:SWEep<n2>:B:MARKer:SETTo:XPOS <xpos>
Corresponds to the softkey operation:
Marker,
Trace A | Trace B,
Set to Value
Parameters:
<xpos> float
Set marker to a position on the X-axis. The unit for entering the
value depends on the unit of the X-axis.
Example: DISPlay:FFT2:B:MARKer:SETTo:XPOS 12.345 Hz
DISPlay:FFT<n2>:OCURsor:MODE <mode>
DISPlay:FFT<n2>:XCURsor:MODE <mode>
DISPlay:WAVeform<n2>:OCURsor:MODE <mode>
DISPlay:WAVeform<n2>:XCURsor:MODE <mode>
DISPlay:BARGraph<n2>:OCURsor:MODE <mode>
DISPlay:BARGraph<n2>:XCURsor:MODE <mode>
DISPlay:SWEep<n2>:OCURsor:MODE <mode>
DISPlay:SWEep<n2>:XCURsor:MODE <mode>
Corresponds to softkey operation:
Cursor
O Cursor
O Vert A | O Vert B | O Vert A-B, O Hor A | O Hor B
Softkey Commands of the Graphical Display