Rohde & Schwarz R&S UPP, User Manual

Page: 815 / 938

Remote Control - Command Description
R&S
®
UPP
799 User Manual 1411.1055.32 ─ 10
DISPlay:BARGraph<n2>:DLISt:FILTer <filter>
DISPlay:SWEep<n2>:DLISt:FILTer <filter>
Corresponds to the softkey operation in the list editor:
Selection
All | Lim Upper | Lim Lower | Lim upp&low | Harmonics | Peaks
When saving a trace by setting "Store Trace as" to "DataList Select" (MMEMory:Sub-
sys<i>:STAS DSELect) or when trace data is read in with the following IEC/IEEE bus
commands:
●
TRACe:Subsys<n2>:LDList:AX?
●
TRACe:Subsys<n2>:LDList:AY?
●
TRACe:Subsys<n2>:LDList:BX?
●
TRACe:Subsys<n2>:LDList:BY?
The IEC/IEEE bus command specifies which data is saved/read.
Parameters:
<filter> ALL | LIMUpper | LIMLower | LIMBoth | HARMonics | PEAKs
ALL
all
LIMUpper
Only those values that exceed the upper limit.
LIMLower
Only the values which are below the lower limit value.
LIMBoth
Only those values that exceed the upper limit and fall below the
lower limit.
HARMonics
Only harmonics
PEAKs
Partial curve peaks
Example: DISPlay:FFT:DLISt:FILTer HARMonics
DISPlay:SWEep<n2>:HISTory <history>
Parameters:
<history> integer
Manual operation: See "History" on page 511
DISPlay:FFT<n2>:MINMax <state>
DISPlay:BARGraph<n2>:MINMax <state>
DISPlay:SWEep<n2>:MINMax <state>
Parameters:
<state> ON | OFF
Traces, Spectrum Displays and Bargraphs