Rohde & Schwarz 1321.0615.02, User Manual

Page: 298 / 581

Receiver Mode
R&S
®
Spectrum Rider FPH
291 User Manual 1321.1011.02 ─ 11
Selecting the scan mode
When you enter the receiver mode, the R&S Spectrum Rider repeatedly measures the
receive frequency or set of frequencies over the measurement time you have defined.
If you want to perform a single measurement or scan only, select single scan mode.
1. Press [SWEEP] key.
2. Select "Single Scan" softkey to perform a single scan or measurement.
3. Select "Cont Scan" softkey to perform a continuous scan or measurement.
When you select single scan mode, the R&S Spectrum Rider performs the measure-
ment once over the measurement time and then stops. In case of frequency scans, the
R&S Spectrum Rider performs one measurement on each receive frequency in the
scan range over the measurement time and stops when it has measured all frequen-
cies that are part of the scan range.
12.2.4 Working with Traces
In Receiver mode, the R&S Spectrum Rider provides several ways to configure the
trace display, like the trace mode or trace mathematics.
For more information, see
●
Chapter 6.2.6.1, "Selecting the Trace Mode" , on page 190
●
Chapter 6.2.6.3, "Working with a Second Trace" , on page 193
●
Chapter 6.2.6.4, "Working with Memory Traces" , on page 194
●
Chapter 6.2.6.5, "Using Trace Mathematics" , on page 194
●
Chapter 12.1.2, "Performing Frequency Scans" , on page 285
12.2.5 Using Transducers
For more information, see Chapter 6.4, "Using Transducer Factors" , on page 210.
12.2.6 Using Limit Lines
For more information, see Chapter 6.2.9, "Using Limit Lines" , on page 206.
12.2.7 Using Isotropic Antenna
For more information, see Chapter 6.1.10, "Using Isotropic Antennas" , on page 165.
Configuring Measurements in Receiver Mode
www.allice.de Allice Messtechnik GmbH