Rohde & Schwarz 1321.0615.02, User Manual

Page: 325 / 581

Remote Commands
R&S
®
Spectrum Rider FPH
318 User Manual 1321.1011.02 ─ 11
Parameters:
<StartFrequency> Range: Depends on the operating mode and is specified in
the datasheet.
*RST: 0 Hz
Default unit: GHz
Example: FREQ:STAR 20MHz
Defines a start frequency of 20 MHz.
[SENSe:]FREQuency:STOP <StopFrequency>
This command defines the stop frequency for measurements in the frequency domain
(span > 0).
Parameters:
<StopFrequency> Range: Depends on the operating mode and is specified in
the datasheet.
*RST: fmax
Default unit: GHz
Example: FREQ:STOP 2000MHz
Defines a stop frequency of 2 GHz.
13.6.2.2 Configuring the Vertical Axis
The following commands configure the vertical (level) axis and level parameters of the
active display.
Commands independent of the operating mode
Note that some of the commands for configuring the vertical axis are also valid for
other operating modes. If a command is available in another mode, it is indicated by
the list in the respective section.
List of commands
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:ADJust
.............................................. 319
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y:SPACing
.........................................................319
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]
......................................................... 319
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:RLEVel
..............................................319
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:RLEVel:OFFSet
................................. 320
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:RPOSition
......................................... 320
INPut:ATTenuation<1...2>
............................................................................................... 320
INPut:ATTenuation:MODE
...............................................................................................321
INPut:ATTenuation:AUTO
............................................................................................... 321
INPut:GAIN:STATe
......................................................................................................... 321
INPut:IMPedance
...........................................................................................................322
[SENSe:]CORRection:TRANsducer<1...2>[:STATe]
........................................................... 322
[SENSe:]CORRection:TRANsducer<1...2>:SELect
............................................................322
[SENSe:]CORRection:TRANsducer<1...2>:UNIT?
............................................................. 323
UNIT<1...2>:POWer
....................................................................................................... 323
Remote Control - Commands
www.allice.de Allice Messtechnik GmbH