Remote Commands
R&S
®
Spectrum Rider FPH
427
User Manual 1321.1011.02 ─ 11
Parameters:
<VideoBW>
Default unit: GHz
Example:
CALC:PMET:PRES:BAND:VID 10MHZ
Defines a video bandwidth of 10 MHz.
13.6.5.8
Reading Out Measurement Results
The following chapter describes commands to read measurement result from the
power sensor.
List of commands
FETCh<1...2>:PMETer
This command queries the results of measurements with the power sensor.
The numeric suffix at FETCh is irrelevant for this command.
Parameters:
<Return values>
The return values depend on the power sensor in use and the
selected suffix at FETCh.
Measurements with R&S FSH-Z1 or R&S FSH-Z18:
FETC1:PMET?
power in dBm.
FETC2:PMET?
n/a
Measurements with R&S FSH-Z14 or R&S FSH-Z44:
FETC1:PMET?
forward power in dBm.
FETC2:PMET?
reflected power in dBm.
Example:
FETC2:PMET?
Returns nothing for R&S FSH-Z1 / R&S FSH-Z18 and the reflec-
ted power for R&S FSH-Z14 / R&S FSH-Z44.
13.6.5.9
Selecting a Telecommunication Standard
These commands apply radio communication standards to measurements with the
power sensor.
Note that the selection of a standard is available only for the power sensors R&S FSH-
Z1, -Z14, -Z18 and Z-44.
List of commands
CALCulate<1...2>:PMETer:PRESet[:STATe]
......................................................................427
CALCulate<1...2>:PMETer:PRESet:SELect
...................................................................... 428
CALCulate<1...2>:PMETer:PRESet[:STATe]
<State>
This command turns on or off the use of a standard.
The numeric suffix at CALCulate is irrelevant for this command.
Remote Control - Commands
www.allice.de
Allice Messtechnik GmbH
