Remote Commands
R&S
®
Spectrum Rider FPH
383
User Manual 1321.1011.02 ─ 11
The suffix at CALCulate and MARKer are irrelevant for this command.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALCulate<1...2>:MARKer<1...6>:FUNCtion:
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics:DISTortion?
<ThdType>
This command queries the total harmonic distortion of the signal.
To get a valid result, you have to perform a complete sweep with synchronization to the
sweep end before reading out the result. This is only possible in single sweep mode.
This command is a query and therefore has no *RST value.
The suffix at CALCulate and MARKer are irrelevant for this command.
Parameters:
<ThdType>
TOTal
<Distortion%>,<DistortiondB>
Pair of values, one showing the THD in %, one in dB.
Example:
CALCulate<1...2>:MARKer<1...6>:FUNCtion:
Usage:
Query only
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics:LIST?
This command queries the position of the harmonics.
To get a valid result, you should perform a complete sweep in single sweep mode
before querying the results.
This command is a query and therefore has no *RST value.
The suffix at CALCulate and MARKer are irrelevant for this command.
Parameters:
<Return values>
returns one value for every harmonic.
The first value is the absolute power of the first harmonic. The
levelunit depends on the unit you have set with the
on page 323 command. The other val-
ues are power levels relative to the first harmonic. The unit for
these is dB.
The total number of return values depends on the number of
harmonics you have set with
MARKer<1...6>:FUNCtion:HARMonics:NHARmonics
Remote Control - Commands
www.allice.de
Allice Messtechnik GmbH
