Remote Commands
R&S
®
Spectrum Rider FPH
395
User Manual 1321.1011.02 ─ 11
Example:
INIT:CONT OFF
DISP:WIND:TRAC:MODE AVER
Turns on single sweep mode and trace averaging.
INIT;*WAI
Starts the measurement and waits for the end of the sweep.
Usage:
Event
INITiate:CONTinuous
<State>
This command selects the sweep mode.
Parameters:
<State>
ON | OFF
ON
Selects continuous sweeps.
OFF
Selects single sweep.
*RST:
ON
Example:
INIT:CONT OFF
Turns on single sweep mode.
13.6.3.6
Configuring the Limit Line
The following chapter describes command necessary to configure the limit line and dis-
play the individual pass/fail measurement results of the analog modulation parameters.
List of commands
CALCulate<1...2>:ADEModulation:LIMit:SELect
................................................................395
CALCulate<1...2>:ADEModulation:LIMit:DELete
............................................................... 396
CALCulate<1...2>:ADEModulation:LIMit:FAIL?
..................................................................396
CALCulate<1...2>:LIMit<1...2>:BEEP[:STATe]
................................................................... 396
CALCulate<1...2>:ADEModulation:LIMit:SELect
<Filename>
This command loads a limit line for the selected measurement mode.
The numeric suffix at CALCulate is irrelevant for this command.
Suffix:
<1...2>
.
1...2
Parameters:
<Filename>
String containing the filename of the limit line.
Example:
CALC:ADEM:LIM:SEL 'GSM.aamlim'
Selects the filename for limit line.
Remote Control - Commands
www.allice.de
Allice Messtechnik GmbH
