Rohde & Schwarz 1321.0615.02, User Manual

Page: 367 / 581

Remote Commands
R&S
®
Spectrum Rider FPH
360 User Manual 1321.1011.02 ─ 11
[SENSe:]CHANnel:TABLe:SELect<1...4> <ChannelTable>
This command selects a channel table configured for the link direction you have
selected with
[SENSe:]CHANnel:TABLe:SET
on page 361.
Note that if you have previously selected a channel table with
[SENSe:]CHANnel:
TABLe:SELect:DOWNlink
on page 360 or
[SENSe:]CHANnel:TABLe:SELect:
UPLink
on page 361, this command replaces that file.
The numeric suffix at SELect is irrelevant for this command.
Suffix:
<1...4>
.
1...4
Parameters:
<ChannelTable> String containing the filename of the channel table.
*RST:
' '
Example: CHAN:TABL:SET UP
Selects channel table selection for uplink signals.
CHAN:TABL:SEL 'TV China.CHNTAB'
Loads the channel table with the name 'TV China' for the uplink.
CHAN:TABL:SEL 'TV Italy.chntab'
or
CHAN:TABL:SEL:UPL 'TV Italy.chntab'
Both commands replace the uplink channel table 'TV China' with
'TV Italy'.
Downlink channel tables are not affected by the commands sent
so far.
FREQ:INP:MODE CHAN
CHAN 10
Select a particular uplink channel (e.g. #10) instead of a (center)
frequency.
To select an additional downlink channel table, use either:
CHAN:TABL:SET DOWN
CHAN:TABL:SEL 'TV Italy.chntab'
or
CHAN:TABL:SEL:DOWN 'TV Italy.chntab'
[SENSe:]CHANnel:TABLe:SELect:DOWNlink <ChannelTable>
This command selects a channel table configured for downlink signals.
Parameters:
<ChannelTable> String containing the name of the channel table.
*RST:
' '
Example: See
[SENSe:]CHANnel:TABLe:SELect<1...4>
on page 360.
Remote Control - Commands
www.allice.de Allice Messtechnik GmbH