Remote Commands
R&S
®
Spectrum Rider FPH
423
User Manual 1321.1011.02 ─ 11
CALCulate<1...2>:PMETer:CPOWer:BANDwidth
<ChannelBW>
This command defines the channel bandwidth.
Available for the channel power meter.
The numeric suffix at CALCulate is irrelevant for this command.
Parameters:
<ChannelBW>
Default unit: GHz
Example:
CALC:PMET:CPOW:BAND 5 MHZ
Sets the channel bandwidth to 5 MHz.
13.6.5.2
Setting the Wavelength
The following chapter describes commands necessary to define the wavelength set-
tings for the operation of optic power sensor.
List of commands
......................................................................................... 423
[SENSe:]PMETer:WAVelength
<Wavelength>
This command sets the wavelength when the optical power sensor is connected.
See the respective optic power sensor specification for the supported wavelength.
Parameters:
<Wavelength>
Default unit: NM
Example:
PMET:WAV 1550 NM
Set wavelength as 1550 nm.
13.6.5.3
Configuring Power Level Readout
The following chapter describes commands that configure the power level readout.
List of commands
CALCulate<1...2>:PMETer:RELative[:MAGNitude]
.............................................................423
CALCulate<1...2>:PMETer:RELative[:MAGNitude]:AUTO
...................................................424
CALCulate<1...2>:PMETer:RELative[:MAGNitude]:OFFSet
................................................ 424
...........................................................................................424
CALCulate<1...2>:PMETer:RELative[:MAGNitude]
<RefLevel>
This command sets the reference value for relative measurements.
The numeric suffix at CALCulate is irrelevant for this command.
Parameters:
<RefLevel>
Default unit: dBm
Remote Control - Commands
www.allice.de
Allice Messtechnik GmbH
