Network Tab
Revised 2017-08-31
Firewall
Drawing No. LP0997-C
- 82 -
Sixnet
®
Series SN/RAM
®
6000 & RAM 9000 Software Manual
Note:
Once any filter is configured for restricting traffic, ALL traffic is then dropped that does not match the
filter(s) for specified interfaces. IPSec traffic for VPN tunnels can also be filtered using these rules.
Click on the
Add
button and the following dialog window appears:
Inbound Interface:
Select an interface associated with the Source Address/Subnet from the drop-down menu.
Source Subnets via Whitelist:
Select a whitelist name for the list of names available in the drop-down menu.
Whitelists are defined in the
Network>Firewall>ALC Rules>Subnet Whitelist Rules
screen.
Outbound Interface:
Select the interface associated with the Destination Address/Subnet.
Destination Address/Subnet (Required):
Enter the network to which the firewall allows access from the
Outbound Interface.
Click on the
Finish
button. You will be returned to the Firewall Access Control List (ACL) Rules dialog window and
the Filter Rules table will now be populated with the recently entered data.
To delete an existing rule, select it in the table and click on the
Delete
button. To edit an existing rule, select it in the
table and click on the
Edit
button.
Click on the
Save
button for changes to be saved without activating the interface until you reboot the unit, the
Apply
button will save your settings and apply them immediately. To revert to the previous defaults, click on the
Revert
button.
