277
Acceleration and Deceleration Operations
Section 7-4
For example, if the physical position is 5,368,709,120 (command units), as
indicated by point P in the above diagram, which exceeds 2,147,483,647
(command units), 1,073,741,824 will be given as the present position (com-
mand units).
The position range for the ABSOLUTE MOVEMENT and RELATIVE MOVE-
MENT commands is
−
2,147,483,648 to 2,147,483,647 (command units) for
the command present position when they are not limited by limit input signals
or software limits.
If the physical position is point P in the diagram, the physical position that can
be moved to using ABSOLUTE MOVEMENT or RELATIVE MOVEMENT is
2,147,483,648 to 6,442,450,943 (command units). The PCU will treat the
position command value and present position in the range as
−
2,147,483,648
to 2,147,483,647 (command units).
Note
With the direct operation position range, the operation for position command
values is different for ABSOLUTE MOVEMENT and RELATIVE MOVEMENT
commands. Refer to
9-4-1 Starting Direct Operation
for further details.
7-4
Acceleration and Deceleration Operations
The acceleration and deceleration operations that can be used when the PCU
is connected to a G5-series Servo Drive, G-series Servo Drive, W-series
Servo Drive, or SMARTSTEP Junior Servo Drive are described here.
7-4-1
Overview of Acceleration/Deceleration Operations
The PCU creates the specified acceleration/deceleration curve for the operat-
ing commands performing position control, such as direct operation or origin
searches. The acceleration/deceleration speed settings are set for each axis
according to the Servo Parameters for acceleration/deceleration and are
enabled for the following acceleration/deceleration operations.
0
P
2,147,483,647
1,073,741,824
−
2,147,483,648
−
2,147,483,648
2,147,483,647
4,294,967,296
5,368,709,120
6,442,450,943
Present position
Physical position
Possible positioning range from point P
Operating command
Acceleration operation
Deceleration operation
ABSOLUTE MOVEMENT/ RELA-
TIVE MOVEMENT
Starting
Changing speed (acceleration)
Changing override (acceleration)
Stopping positioning
Changing speed (deceleration)
Changing override (deceleration)
JOG
Starting jogging
Changing speed (acceleration)
Changing override (acceleration)
Stopping jogging
Changing speed (deceleration)
Changing override (deceleration)
ORIGIN SEARCH
See
7-4-4 Origin Search Accelera-
tion/Deceleration Operations
See
7-4-4 Origin Search Accelera-
tion/Deceleration Operations
Summary of Contents for CJ1W-NC271 - 12-2009
