Omron CJ1W-NC271 - 12-2009, Operation Manual

Page: 345 / 687

317
Present Position Preset
Section 8-3
8-3 Present Position Preset
PRESENT POSITION PRESET changes the present position to any position
and then establishes the origin.
8-3-1 Outline of Operation
When the PRESENT POSITION PRESET Bit is turned ON, the present posi-
tion is changed to the value set as the position command value in the Axis
Operating Output Memory Areas. during present position preset, the Busy
Flag is ON (1 cycle time min.). The Busy Flag turns OFF to indicate that pre-
set operation has been completed. After this, the origin is established. If the
present position is changed to “0,” then that position will become the origin.
8-3-2 Data Settings for Present Position Preset
A simple explanation of the main parameters and data used to execute
PRESENT POSITION PRESET is provided here. For details on command
units, refer to
7-2 Control Units .
The setting units for parameters and data depend on the specified command
unit.
Servo Parameter Area Command Unit Parameters
The command unit default setting is pulses.
Model Parameter
No.
Parameter name Unit Setting
range
Parameter
size
Default
setting
R88D-KN
@
-
ML2
Pn009 Electronic gear ratio numerator --- 1 to
1073741824 4 1
Pn010 Electronic gear ratio denominator --- 1 to
1073741824 4 1
R88D-GN
@
-
ML2
Pn205 Electronic gear ratio G1 (numerator) --- 1 to
1073741824 4 1
Pn206 Electronic gear ratio G2 (denominator) --- 1 to
1073741824 4 1
R88D-WT
@
Pn202 Electronic gear ratio G1 (numerator) --- 1 to 65535 2 4
Pn203 Electronic gear ratio G2 (denominator) --- 1 to 65535 2 1
R88D-WN
@
-
ML2
Pn20E Electronic gear ratio G1 (numerator) --- 1 to
1073741824 4 4
Pn210 Electronic gear ratio G2 (denominator) --- 1 to
1073741824 4 1
SMART-
STEP Junior Pn20E Electronic gear ratio G1 (numerator) --- 1 to
1073741824 4 1
Pn210 Electronic gear ratio G2 (denominator) --- 1 to
1073741824 4 1