Managed Switch CLI Manual, Release 8.0
Switching Commands
3-56
v1.0, July 2009
set garp timer join
This command sets the GVRP join time for one port (Interface Config mode) or all (Global Config
mode) and per GARP. Join time is the interval between the transmission of GARP Protocol Data
Units (PDUs) registering (or re-registering) membership for a VLAN or multicast group. This
command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds).
The value 20 centiseconds is 0.2 seconds.
no set garp timer join
This command sets the GVRP join time (for one or all ports and per GARP) to the default and only
has an effect when GVRP is enabled.
set garp timer leave
This command sets the GVRP leave time for one port (Interface Config mode) or all ports (Global
Config mode) and only has an effect when GVRP is enabled. Leave time is the time to wait after
receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry.
This can be considered a buffer time for another station to assert registration for the same attribute
in order to maintain uninterrupted service. The leave time is 20 to 600 (centiseconds). The value
60 centiseconds is 0.6 seconds.
Default
20
Format
set garp timer join
<10-100>
Mode
• Interface Config
• Global Config
Format
no set garp timer join
Mode
• Interface Config
• Global Config
Default
60
Format
set garp timer leave
<20-600>
Mode
• Interface Config
• Global Config
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...