Managed Switch CLI Manual, Release 8.0
Routing Commands
4-28
v1.0, July 2009
Ip-address:
Destination broadcast or host address to be used when forwarding UDP broadcasts.
You can specify 0.0.0.0 to indicate not to forward the UDP packet to any host and use
"255.255.255.255"
to broadcast the UDP packets to all hosts on the target subnet.
udp-port-list:
The broadcast packet destination UDP port number to forward. If not specified,
packets for the default services are forwarded to the helper address. Valid range, 0-65535.
no ip helper-address (Global Config)
Use this command to remove the IP address from the previously configured list. The no command
without an
<
ip-address
>
argument removes the entire list of helper addresses on that interface.
ip helper-address
Use this command to add a unicast helper address to the list of helper addresses on an interface.
This is the address of a DHCP server. This command can be applied multiple times on the routing
interface to form the helper addresses list until the list reaches the maximum supported helper
addresses.
Default
Disabled
Format
ip helper-address <ip-address>
{<1-65535>|dhcp|domain|isakmp|mobile-ip|nameserver|
netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time}
Mode
Global Config
Format
no ip helper-address {<ip-address>}
{<1-65535>|dhcp|domain|isakmp|mobile-ip|nameserver|
netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time}
Mode
GlobalConfig
Format
ip helper-address <ip-address>
{<1-65535>|dhcp|domain|isakmp|mobile-ip|nameserver|
netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time}
Mode
Interface Config
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
