Managed Switch CLI Manual, Release 8.0
Utility Commands
6-87
v1.0, July 2009
show sflow receivers
Use this command to display configuration information related to the sFlow receivers.
Example: The following shows example CLI display output for the command.
(switch) #show sflow receivers 1
Receiver Index................................. 1
Owner String...................................
Time out....................................... 0
IP Address:.................................... 0.0.0.0
Address Type................................... 1
Port........................................... 6343
Datagram Version............................... 5
Maximum Datagram Size.......................... 1400
Poller Interval
The number of seconds between successive samples of the counters associated with this
data source.
Format
show sflow receivers [<index>]
Mode
Privileged EXEC
Field
Description
Receiver Index
The sFlow Receiver associated with the sampler/poller.
Owner String
The identity string for receiver, the entity making use of this sFlowRcvrTable entry.
Time Out
The time (in seconds) remaining before the receiver is released and stops sending
samples to sFlow receiver.
Max Datagram
Size
The maximum number of bytes that can be sent in a single sFlow datagram.
Port
The destination Layer4 UDP port for sFlow datagrams.
IP Address
The sFlow receiver IP address.
Address Type
The sFlow receiver IP address type. For an IPv4 address, the value is 1 and for an IPv6
address, the value is 2.
Datagram
Version
The sFlow protocol version to be used while sending samples to sFlow receiver.
Field
Description
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
