Managed Switch CLI Manual, Release 8.0
Quality of Service (QoS) Commands
5-18
v1.0, July 2009
match source-address mac
This command adds to the specified class definition a match condition based on the source MAC
address of a packet. The
<address
>
parameter is any layer 2 MAC address formatted as six,
two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The
<macmask
>
parameter is a layer 2 MAC address bit mask, which may not be contiguous, and is formatted as
six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc).
match srcip
This command adds to the specified class definition a match condition based on the source IP
address of a packet. The
<ipaddr>
parameter specifies an IP address. The
<ipmask>
parameter specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits.
match srcip6
This command adds to the specified class definition a match condition based on the source IP
address of a packet.
match srcl4port
This command adds to the specified class definition a match condition based on the source layer 4
port of a packet using a single keyword or numeric notation. To specify the match condition as a
single keyword notation, the value for
<portkey>
is one of the supported port name keywords
Default
none
Format
match source-address mac <address> <macmask>
Mode
Class-Map Config
Ipv6-Class-Map Config
Default
none
Format
match srcip <ipaddr> <ipmask>
Mode
Class-Map Config
Default
none
Format
match srci
p6 <source-ipv6-prefix/prefix-length>
Mode
Ipv6-Class-Map Config
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
