Managed Switch CLI Manual, Release 8.0
Management Commands
7-54
v1.0, July 2009
The following shows an example of the command.
(Switch) (Config) #radius server attribute 4 192.168.37.60
(Switch) (Config) #radius server attribute 4
radius server host
This command configures the IP address or DNS name to use for communicating with the
RADIUS server of a selected server type. While configuring the IP address or DNS name for the
authenticating or accounting servers, you can also configure the port number and server name. If
the authenticating and accounting servers are configured without a name, the command uses the
‘Default_RADIUS_Auth_Server’ and ‘Default_RADIUS_Acct_Server’ as the default names,
respectively. The same name can be configured for more than one authenticating servers and the
name should be unique for accounting servers. The RADIUS client allows the configuration of a
maximum 32 authenticating and accounting servers.
If you use the
<auth>
parameter, the command configures the IP address or hostname to use to
connect to a RADIUS authentication server. You can configure up to 3 servers per RADIUS client.
If the maximum number of configured servers is reached, the command fails until you remove one
of the servers by issuing the “no” form of the command. If you use the optional
<port>
parameter, the command configures the UDP port number to use when connecting to the
configured RADIUS server. The
<port>
number range is 1 - 65535, with 1812 being the default
value.
If you use the
<acct>
token, the command configures the IP address or hostname to use for the
RADIUS accounting server. You can only configure one accounting server. If an accounting server
is currently configured, use the “no” form of the command to remove it from the configuration.
The IP address or hostname you specify must match that of a previously configured accounting
server. If you use the optional
<port>
parameter, the command configures the UDP port to use
Format
no radius server attribute <4> [<
ipaddr
>]
Mode
Global Config
Note:
To re-configure a RADIUS authentication server to use the default UDP
<port>
,
set the
<port>
parameter to 1812.
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
