Managed Switch CLI Manual, Release 8.0
Quality of Service (QoS) Commands
5-14
v1.0, July 2009
match ip6flowlbl
This command adds to the specified class definition a match condition based on the IP6flowlbl of
a packet. The
label
is the value to match in the Flow Label field of the IPv6 header (range 0-
1048575).
match destination-address mac
This command adds to the specified class definition a match condition based on the destination
MAC address of a packet. The
<macaddr>
parameter is any layer 2 MAC address formatted as
six, two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The
<macmask
>
parameter is a layer 2 MAC address bit mask, which need not be contiguous, and is
formatted as six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc).
match dstip
This command adds to the specified class definition a match condition based on the destination IP
address of a packet. The
<ipaddr>
parameter specifies an IP address. The
<ipmask>
parameter
specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits.
Format
match ip6flowlbl <
label
>
Mode
Ipv6-Class-Map Configuration mode
Note:
This command is not available on the GSM73xxSv1 platform.
Default
none
Format
match destination-address mac <macaddr> <macmask>
Mode
Class-Map Config
Ipv6-Class-Map Config
Default
none
Format
match dstip <ipaddr> <ipmask>
Mode
Class-Map Config
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
