Managed Switch CLI Manual, Release 8.0
Switching Commands
3-79
v1.0, July 2009
storm-control broadcast rate
Use this command to configure the broadcast storm recovery threshold for an interface in packets
per second. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is
dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold.
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for an interface and
disables broadcast storm recovery.
storm-control broadcast (Global)
This command enables broadcast storm recovery mode for all interfaces. If the mode is enabled,
broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface
increases beyond the configured threshold, the traffic will be dropped. Therefore, the rate of
broadcast traffic will be limited to the configured threshold.
no storm-control broadcast
This command disables broadcast storm recovery mode for all interfaces.
Default
0
Format
storm-control broadcast rate
<0-14880000>
Mode
Interface Config
Format
no storm-control broadcast rate
Mode
Interface Config
Default
disabled
Format
storm-control broadcast
Mode
Global Config
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
