NETGEAR FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch, Cli Manual

Page: 401 / 558

Managed Switch CLI Manual, Release 8.0
Utility Commands 6-84
v1.0, July 2009
no sflow receiver
Use this command to set the sFlow collector parameters back to the defaults.
sflow sampler
A data source configured to collect flow samples is called a poller. Use this command to configure
a new sFlow sampler instance for this data source if <
rcvr_idx > is valid.
Receiver IP The sFlow receiver IP address. If set to 0.0.0.0, no sFlow datagrams will be sent. The
default is 0.0.0.0.
Receiver Port The destination Layer4 UDP port for sFlow datagrams. The range is 1-65535. The default
is 6343.
Format
no sflow receiver < indx > {ip < ip-address > | maxdatagram < size > | owner
< string > timeout < interval > | port < 14-port >}
Mode Global Config
Format
sflow sampler {< rcvr-indx > | rate < sampling-rate > | maxheadersize
< size >}
Mode Interface Config
Field Description
Receiver Index The sFlow Receiver for this sFlow sampler to which flow samples are to be sent. A value
of zero (0) means that no receiver is configured, no packets will be sampled. Only active
receivers can be set. If a receiver expires, then all samplers associated with the receiver
will also expire. Possible values are 1-8. The default is 0.
Maxheadersize The maximum number of bytes that should be copied from the sampler packet. The range
is 20-256. The default is 128. When set to zero (0), all the sampler parameters are set to
their corresponding default value.
Sampling Rate The statistical sampling rate for packet sampling from this source. A sampling rate of 1
counts all packets. A value of zero (0) disables sampling. A value of N means that out of N
incoming packets, 1 packet will be sampled. The range is 1024-65536 and 0. The default
is 0.
Field Description