Managed Switch CLI Manual, Release 8.0
Quality of Service (QoS) Commands
5-48
v1.0, July 2009
Auto-Voice over IP Commands
This section describes the commands you use to configure Auto-Voice over IP (VoIP) commands.
The Auto-VoIP feature explicitly matches VoIP streams in Ethernet switches and provides them
with a better class-of-service than ordinary traffic. When you enable the Auto-VoIP feature on an
interface, the interface scans incoming traffic for the following call-control protocols:
•
Session Initiation Protocol (SIP)
•
H.323
•
Skinny Client Control Protocol (SCCP)
When a call-control protocol is detected, the switch assigns the traffic in that session to the highest
CoS queue, which is generally used for time-sensitive traffic.
auto-voip all
Use this command to enable VoIP Profile on the interfaces of the switch.
Match All
Indicates whether this access list applies to every packet. Possible values are True or
False.
Protocol
The protocol to filter for this rule.
Source IP
Address
The source IP address for this rule.
Source L4 Port
Keyword
The source port for this rule.
Destination IP
Address
The destination IP address for this rule.
Destination L4
Port Keyword
The destination port for this rule.
IP DSCP
The value specified for IP DSCP.
Flow Label
The value specified for IPv6 Flow Label.
Log
Displays when you enable logging for the rule.
Assign Queue
The queue identifier to which packets matching this rule are assigned.
Mirror Interface
The unit/slot/port to which packets matching this rule are copied.
Redirect
Interface
The unit/slot/port to which packets matching this rule are forwarded.
Term
Definition
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
