Managed Switch CLI Manual, Release 8.0
Utility Commands
6-4
v1.0, July 2009
boot autoinstall retry-count
This command is used to set the number of attempts to download a configuration. The valid range
is from 1 to 6.
no boot autoinstall retry-count
This command is used to reset the number to the default. The default number is 3.
Dual Image Commands
The software supports a dual image feature that allows the switch to have two software images in
the permanent storage. You can specify which image is the active image to be loaded in
subsequent reboots. This feature allows reduced down-time when you upgrade or downgrade the
software.
delete
This command deletes the supplied image file from the permanent storage. The image to be
deleted must be a backup image. If this image is the active image, or if this image is activated, an
error message displays. The optional
<unit>
parameter is valid only on Stacks. Error will be
returned, if this parameter is provided, on Standalone systems. In a stack, the
<unit>
parameter
identifies the node on which this command must be executed. When this parameter is not supplied,
the command is executed on all nodes in a Stack.
Default
3
Format
boot autoinstall retry-count
Mode
Privileged EXEC
Format
no boot autoinstall retry-count
Mode
Privileged EXEC
Format
delete [<unit>] {image1 | image2}
Mode
Privileged EXEC
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
